Proper use of saw blade and band saw machine

Suggestions for proper use of saw blade and band saw machine

• Never open the purchased saw blade by tapping or throwing.
• Remove the blade edge guard after inserting it into the band saw machine.
• To use the saw blade and seal it, you must use a maximum of 50% of the set progress.

(In the first 10 cuts, the machine speed is low and the loading speed is low, in the second 10 cuts, the speed and yield are 1.2, and for the rest of the cuts, use the usual procedure)

• The blade is under proper tension.
• Before using the device, learn the instructions of the device manufacturer and the uses and limitations of the device.
• Fix the machine to the ground completely to reduce the vibration of the band saw.
• Do not clean the chips on the machine by hand or with compressed air, use a brush or pen to do this.
• After adjusting the machine and parts for cutting, make sure that the jack goes down at a balanced speed.
• Maximum blade life and minimum cost are obtained by choosing the right cutting speed and amount of coolant.
• Coolant concentration can be changed according to the hardness and type of workpiece (typically 1 liter of oil in 20 liters of water for normal sections and 1 liter of oil in 10 liters of water for hard sections)